Part 1: Introduction; Overview; Tool Required; Reference Diagram - MachMotion Apollo III Manual

8 | P a g e
Improper installation of this motion controller can cause DEATH, INJURY or serious
PROPERTY DAMAGE. Do not attempt to install this controller until thoroughly

1 PART 1: INTRODUCTION

1.1 Overview

The Apollo III is MachMotion's Ethernet motion controller. It uses differential or single-ended step and direction to
control up to 6 axes with full encoder feedback (full closed loop). It also has 16 inputs, 8 outputs, excellent
position resolution, two MPG inputs, and spindle encoder feedback

1.2 Tool Required

To use the Apollo III, the following items are necessary:
•
24VDC Power Supply
•
Emergency Stop Circuit
•
Control with Mach3 and Ethernet Port
•
Small flat head screw driver
MachMotion CNC controls come with the above items, except the screw driver.

1.3 Reference Diagram

Use the diagram below as a reference throughout the manual.
WARNING
reading and understanding this manual.
Apollo III Using Mach3