Table of Contents
Advertisement
32 |
P a g e
Note: The note below the input signal window is referencing parallel port systems. Ignore this.
3. Enable the input by clicking on the red "X". If it is a green check mark, it is already enabled.
4. Set the Port Number and Pin Number to the desired input.
Note: All input port numbers are 11 and the pin numbers correspond to the X number
5. To change when the input is active, click on the Active Low column. A green check mark means that the
input is active low and a red X means that the input is active high.
The input is now be set up.
6 OUTPUT SETUP
6.1 Generic Outputs
The Apollo III has 8 logic outputs that can be used for any low current application. They are located on the small
green terminal block as shown below.
FIGURE 36 INPUT CONFIGURATION
(X4 would be pin 4)
Apollo III Using Mach3
Advertisement
Table of Contents
