Using Outputs - MachMotion Apollo III Manual

10. Enable the output by setting the Enabled box to a green check.
11. Set the Port Number to 11 and the Pin Number to the corresponding Y number (Y3 would be pin
number 3).
12. Set the Active Low column to a green check for a normally closed signal or red x for normally open.

14.3 Using Outputs

Outputs 5-10 can be controlled with M-Codes. One M-Code turns an output on, and the other M-Code turns the
output off. Use the table below for a reference.
Custom M-Codes
M200
M201
M202
M203
M204
M205
M206
M207
M208
M209
M210
M211
TABLE 19 M-CODES FOR OUTPUTS
Functions
Output 5 on
Output 5 off
Output 6 on
Output 6 off
Output 7 on
Output 7 off
Output 8 on
Output 8 off
Output 9 on
Output 9 off
Output 10 on
Output 10 off
Apollo III Using Mach3
Default Output
Y2
Y3
Y4
Y5
Y6
Y7
P a g e | 79