Table of Contents
Advertisement
P a g e
| 47
FIGURE 55 HICON CONFIGURATION WINDOW
At any time while inside the plugin, clicking on the [UPDATE HICON] button will transmit the settings to the Apollo
III motion controller. Clicking [OK] will also transmit the settings to the controller and save them in the selected
Mach3 profile (e.g. Mach3Mill, Mach3Turn, etc).
To exit the plugin, press [OK] and then [OK] again on the PlugIn Control and Activation window.
Now, with a brief overview of the Apollo III, it is time to start configuring the controller.
Apollo III Using Mach3
Advertisement
Table of Contents
