Configuring Outputs - MachMotion Apollo III Manual

78 | P a g e

14.2 Configuring Outputs

To configure an output, follow the procedure below.
7. On the menu bar click on Config->Ports and Pins.
8. Select the Output Signals tab.
9. Scroll down to the desired output (There are 20 outputs that can be used).
+ 10V Supply
0-10 CCW CW GND GND Y6 Y4 C2+
GND CCW CW GND GND Y7 Y5 GND GND Y3
10V Load
FIGURE 105 CUSTOM 250MA OUTPUTS
FIGURE 106 OUTPUT CONFIGURATION
Apollo III Using Mach3
-
+ 48V Supply
24V Y2 Y0 C1+ 24V HEN 5EN 24V 5V
Y1 GND HEN SOV EXT GND
24EN
48V Load
-