Table of Contents
Advertisement
Profile Series v.G1.5 Rim Exit Device
Installation Instructions: 8877/8878 Rim Type Exit Device
6
Step #1 – Prepare Door
A. Verify Hand and Bevel of Door
• This device is non-handed.
• Door should be fitted and hung.
• Verify box label for size of exit device and function.
B. Door Preparation
If using a mullion, install prior to installing hardware.
Doors should be pre-prepped.
Prepare door according to appropriate template:
• Exit installation instructions A6770
• Door Manufacturer's Template 4640 (Metal and Wood)
Note: Wood door has additional cutout if installation includes a cylinder.
Step #2 – Position Exit Trim (ET)
For exterior applications, use ET gasket (P/N 52-0263)
to seal between ET escutcheon and outside door surface.
1A. For wood doors: Route ET wire harness through the cylinder
hole, out the other side, and through the wire run channel to
the controller cutout.
1B. For metal doors: Route ET wire harness
through the cylinder hole and door
and out the controller cutout.
2.
Position and hold ET trim on the door.
3.
Connector from ET harness connects
to connector from chassis (Fig. 2)
Left Hand
Reverse Bevel
LHRB
Exit trim Gasket
(Exterior Applications)
Exit trim
Outside of Door
1-800-810-WIRE • www.sargentlock.com • A7856C
Inside
Right Hand
Reverse Bevel
Outside
RHRB
Fig. 1
ET Wire Harness
(from motor)
Fig. 2
9
Hide quick links:
Advertisement
Table of Contents
