Battery Keeper - Sargent v.G1.5 Installation Instructions Manual

Step 9 – Install and Secure Inside Escutcheon
1. Secure the inside escutcheon using two #8-32
screws through top and bottom of the
escutcheon (Fig. 9).
Thread into outside escutcheon.
2. Straighten escutcheons and tighten securely,
being careful to avoid pinching wires.
Step #10 – Install and Remove Batteries*
A. Install Batteries and Keeper
1. Place (6) "AA" batteries into the compartment, being careful to properly align polarity (Fig. 10A).
2. To install battery keeper, insert the tabs on the bottom of the keeper into the battery compartment slots
and press the keeper tightly against batteries and inserting tabs into bottom slots.
• For RF technology, use RF Technology lock information "RF Technology Lock" on page 20.
IMPORTANT:
• Test for proper operation before closing door.
B. Remove Battery Keeper
To remove the battery keeper, pull the keeper away from the batteries (Fig. 10B).
+
-
+
+
-
+
20 1-800-810-WIRE • www.sargentlock.com • A7856C
*
Do not install batteries if controller is powered by external power supply.
Bottom Tabs

(Battery Keeper)

Fig. 10A
Profile Series v.G1.5 Mortise Exit Device
Battery Keeper
Battery Cover
Security
Screw
Security Tool
(P/N 01-0297, Included
Fig. 9A
Tip Out
Battery Keeper
Keeper Tabs
Fig. 10B