Universal Serial Bus (Usb) Socket - Triumph Rocket 3 TFC 2020 Owner's Handbook Manual

General Information
Universal Serial Bus (USB)
Socket
Warning
The USB socket is not waterproof. Do
not connect electronic devices whilst it
is raining.
Water in the USB socket could lead
to an electrical problem, resulting in
motorcycle damage, loss of motorcycle
control and an accident.
A Universal Serial Bus (USB) socket
is provided, located in the storage
compartment under
connector provides a 5 Volt, 2 Amp
power supply which is suitable for
charging electronic devices such as
mobile phones,
devices.
To access the USB socket:
• Remove the seat.
• Open the storage compartment. The
USB socket is located at the back of
the storage compartment.
• Connect the device using a suitable
USB cable, then store the device
and USB cable in the space available
in the storage compartment.
90
the seat.
cameras and GPS
Make sure that all electronic devices
and cables are safely secured under
the seat when riding.
Make sure there is sufficient space
surrounding any electronic devices for
the seat to close without causing any
damage to the electronic device or the
motorcycle.
• Fit the seat, making sure that the
device or USB cable is not trapped.
• Turn the ignition on and start the
engine.
The
Do not leave the ignition switch in
the ON position unless the engine
is running as this will discharge the
battery.
• When
charging, remove the seat and
disconnect the device.
• Close the storage compartment and
refit the seat.
Note
The USB socket is protected by a
chassis ECM, which will automatically
cut power to the socket in the event of
an overload.
Power can be restored to the USB
socket by turning the ignition switch off
then on again, provided that the socket
is not still overloaded.
Caution
Caution
the device has finished