Protech Systems PA-6822 User Manual page 106

ESC V n
[Name] Turn 90 degree clockwise rotation mode on/off
ASCII ESC V n
[Format] Hex. 1B 56 n
Decimal 27 86 n
0 ≤ n≤ 1, 48≤ n ≤49
[Range]
Initial Value n = 0
Specifies or cancels character 90 degree clockwise rotation.
n
0, 48
1, 49
[Description]
ESC W xL xH yL yH dxL dxH dyL dyH
[Name] Set printing area in page mode
ASCII ESC W xL xH yL yH dxL dxH dyL dyH
[Format] Hex. 1B 57 xL xH yL yH dxL dxH dyL dyH
Decimal 27 87 xL xH yL yH dxL dxH dyL dyH
0 ≤ xL, xH, yL, yH, dxL, dxH, dyL, dyH ≤ 255
[Range] However, this excludes dxL = dxH = 0 or dyL = dyH = 0
Initial Value xL = xH = yL = yH = 0
Sets the print region position and size.
[Description]
PA-6822 Series User Manual
Function
Turns off 90 degree clockwise rotation mode
Turns on 90 degree clockwise rotation mode
Underlines are not applied to characters rotated 90 degrees clockwise even
when ESC !,ESC - or FS - commands are given.
If 90 degree clockwise rotation is specified, double-wide and double-tall
commands in the 90 rotation mode enlarges characters in the opposite
directions to double-wide and double-tall commands.
This command only affects printing in standard mode.
In page mode, this command is only effective for the setting.
This command is effective for ANK and Chinese characters.
Horizontal direction starting point [(xL + xH x 256) x basic calculated pitch]
Vertical direction starting point [(yL + yH x 256) x basic calculated pitch]
Horizontal direction length [(dxL + dxH x 256) basic calculated pitch]
Vertical direction length = [(dyL + dyH x 256) basic calculated pitch]
(X+Dx-1)<576 (3 inch,basic calculated pitch=1);(X+Dx-1)<432 (2 inch,basic
calculated pitch=1)
(Y+Dy-1)<768 (basic calculated pitch=1);
If (horizontal starting position + printing area width) exceeds the printable
area, the printing area width is automatically set to (horizontal printable
area - horizontal starting position).
If (vertical starting position + printing area height) exceeds the printable
area, the printing area height is automatically set to (vertical printable area
- vertical starting position).
Chapter 3 Software


Page