Protech Systems PA-6822 User Manual page 100

ESC $ nL nH
[Name] Set absolute print position.
ASCII
[Format] Hex.
Decimal
[Range] 0 ≤ (nL + nH x 256) ≤ 65535 (0 ≤ nH ≤ 255, 0 ≤ nL ≤ 255)
This command specifies the next print starting position in reference to the left
edge of the print area. The printing start position is calculated using
[Description]
(nL + nH x 256) x (vertical or horizontal motion units). Specifications exceeding
the print range are ignored.
ESC * m nL nH d1...dk
[Name] Select bit image mode
ASCII
[Format] Hex.
Decimal 27 42 m nL nH d1...dk
m = 0,1,32,33
0 ≤ nL ≤ 255
[Range]
0 ≤ nH ≤ 3
0 ≤ d ≤ 255
Selects a bit-image mode in mode m for the number of dots specified by nL and
nH.
m = 1,33 : (nL+nH×256)<576 (3 inch);(nL+nH×256)<432 (2 inch).
m = 0,32 : (nL+nH×256)<288 (3 inch);(nL+nH×256)<216 (2 inch).
m
[Description]
0
1
32
33
ESC - n
[Name] Turn underline mode on/off.
ASCII
[Format] Hex.
Decimal
0 ≤ n ≤ 2
[Range]
Initial Value n = 0
This command enables the print data following it to be printer out underlined.
The underline mode varied depending on the following values of n:
n
[Description]
0
1
2
PA-6822 Series User Manual
ESC $ nL nH
1B 24 nL nH
27 36 nL nH
ESC * m nL nH d1...dk
1B 2A m nL nH d1...dk
Number
of
Mode
Vert. Dir.
Dots
8 dot single
8
density
8 dot double
8
density
24 dot single
24
density
24 dot
double 24
density
ESC - n
1B 2D n
27 45 n
Function
Turns off underline mode
Turns on underline mode, set at 1-dot thick
Turns on underline mode, set at 2-dot thick
Chapter 3 Software
Density of Density of
Vert. Dir. Hor. Dir.
Dots Dots
67 DPI 101 DPI
67 DPI 203 DPI
203 DPI 101 DPI
203 DPI 203 DPI
Data Count (k)
nL+nH×256
nL+nH×256
(nL+nH×256)
×3
(nL+nH×256)
×3
Page