Protech Systems PA-6822 User Manual page 102

ESC D n1...nk NUL
[Name] Set horizontal tab position
ASCII
[Format] Hex.
Decimal 27
1 ≤ n ≤ 255
[Range]
0 ≤ k ≤ 32
Sets horizontal tab position
n specifies the column number for setting a horizontal tab position from the left
[Description]
margin or the beginning of the line.
k indicates the number of horizontal tab positions to be set.
ESC E n
[Name] Turn emphasized mode on / off.
ASCII
[Format] Hex.
Decimal
0 ≤ n ≤ 255
[Range]
Initial Value n = 0
This command turns emphasized mode on or off by toggling the least significant bi
of n like following.
[Description]
When the LSB of n is 0, emphasized mode is turned off.
When the LSB of n is 1, emphasized mode is turned on.
ESC G n
[Name] Turn double-strike mode on/off.
ASCII
[Format] Hex.
Decimal
0 ≤ n ≤ 255
[Range]
Initial Value n = 0
Specifies or cancels double printing.
[Description]
ESC J n
[Name] Print and feed paper.
ASCII
[Format] Hex.
Decimal
[Range] 0 ≤ n ≤ 255
This command prints the data in the print buffer and feeds the paper [n X
[Description] vertical motion unit].
PA-6822 Series User Manual
ESC D n1...nk NUL
1B 44 n1...nk NUL
68 n1...nk NUL
ESC E n
1B 45 n
27 69 n
ESC G n
1B 47 n
27 71 n
Cancels double printing when n = <*******0>B.
Specifies double printing when n = <*******1>B.
n is effective only when it is the lowest bit.
This printer is not capable of double printing, so the print is the same as
when using emphasized printing.
This command is enabled for ANK characters
ESC J n
1B 4A n
27 74 n
Sets the print position to the beginning of the next line after printing.
Chapter 3 Software
Page