Siemens SIPROTEC Manual page 516

Mounting and Commissioning
3.1 Mounting and Connections
Table 3-13
Jumper
X51
X60
X61
X62
X63
X64
1)
Not for variant with sensitive earth fault detection
Contacts of relays for binary outputs BO13, BO14 and BO15 can be configured as normally open or normally
closed contacts (see also General Diagrams in the Appendix).
Table 3-14
For Jumper
BO13
BO14
BO15
1)
As-supplied state
The relays for the binary outputs BO8 to BO12 can be connected to common potential, or configured individu-
ally for BO8, BO11 and BO12 (BO9 and BO10 are without function in this context) (see also General Diagrams
in the Appendix).
Table 3-15
Jumper
X80
X81
X82
1)
As-supplied state
Jumpers X71, X72 and X73 serve for setting the bus address. Their position must not be changed. The follow-
ing table shows the preset jumper positions.
Table 3-16
Jumper
X71
X72
X73
516
Jumper setting for Nominal Current or Measuring Range
Nominal current 1 A
Measuring range 20 A
1)
Jumper setting for the contact type of the relay for BO13, BO14 and BO15
Open in quiescent state (NO)
X41
X42
X43
Jumper settings for the configuration of the common potential from BO8 to BO11 or for the
setting of BO8, BO11 and BO12 as single relays
BO8 to BO12 connected to common
potential
1-2, 3-4
1-2, 3-4
2-3
Jumper setting of the module addresses of the input/output board C-I/O-2
Factory setting
1-2 (H)
1-2 (H)
2-3 (L)
1-2
1-2
2-5
2-5
2-5
2-5
1)
1-2
1-2
1-2
BO8, BO11, BO12 configured as single relays
1)
Nominal current 5 A
Measuring range 100 A
1-2
2-3
3-5
3-5
3-5
3-5
Closed in quiescent state (NC)
2-3
2-3
2-3
(BO9, BO10 without function)
2-3, 4-5
2-3, 4-5
1-2
SIPROTEC, 7SD5, Manual
C53000-G1176-C169-5, Release date 02.2011