Cautions When Using E-Rds; Setting Procedure - Canon LBP351 Series Service Manual

Functional cat-
egory
Data transmis-
Sublog
sion:
Operation in- Operation check
struction

Cautions when Using E-RDS

• The following settings in service mode must not be change unless there are specific instructions to do so.
Changing these values will cause error in communication with UGW.
• Port number of UGW
SERVICE MODE > NETWORK GR. > E-RDS > RGW-PORT
Default :
• If the e-Maintenance/ imageWARE Remote contract of the device is invalid, be sure to turn OFF the E-RDS setting (E-RDS :
0).
• The following restrictions apply when enabling IPv6 in the network settings.
• If the router advertisement expires while the machine is in the sleep mode when only a stateless address is enabled,
transmission will fail immediately after the machine returns from the sleep mode.
• When only a manual address is enabled, it is necessary to set a default router address.
• When only DHCPv6 is enabled, transmission fails because the router address is unknown.

Setting Procedure

■ Preparation
Since this function communicates with the UGW server, it is necessary to connect to the external network.
Check the following items, and make the settings if not yet set.
• IP address settings
• DNS server settings
*1
• Proxy server settings
• Installation of CA certificate (arbitrary
CAUTION:
• Obtain the information on the network environment from the system administrator of the user.
• When having changed the network settings, turn OF and then ON the main power of the machine.
*1. If authentication is necessary, make the settings of the authentication information as well.
*2. When using a certificate other than those pre-installed in the device
Sub category
*2
)
Send data such as device Sublogs and DCON logs to the server.
Contact the server to check if there is processing to be executed, and receive
the
following instructions if any.
• Change the schedule
• Change the alarm level
• Change the alert filter
89
3. Technical Explanation (System)
Description