Canon LBP351 Series Service Manual page 55

3. Confirm that the following information is set, and click [Cancel] if the settings are correct. If incorrect information
is set, correct it and click [Configure].
• [Delivery Server URL] : https://device.c-cdsknn.net/cds_soap/updaterif
• [Log Level] : 1 to 4
CAUTION:
The larger the value of the log level is, the more detailed the output log is (see the table below). Since changing the log
level setting affects the performance, do not set a higher level than required. (Unless asked to do so by the Support Dept.
of the sales company or the Canon R&D.)
Especially when the level 4 is set, the performance will be significantly lower and it will take time to collect logs.
Log Output
Type
0
Trace -
Information -
Important -
Message
Ordinary Er- -
ror
System Error Yes
4. Click [Yes] when a dialog box confirming whether you want to update the settings is displayed.
This completes the procedure for confirming the URL setting of the distribution server.
Communication Test with the Distribution Server
This section describes how to check if the communication is normally done to the distribution server and/or the file server.
NOTE:
Since the server accessed by the CDS function and the server accessed by the RDS function differ, make sure to perform a
communication test for the CDS function even if the communication test for the RDS function is successful.
1. Access the following URL from the browser on a PC connected to the same network as this machine, and log in to
the management screen.
URL : https://<machine's IP address>:84433/svm/
Password : *28*
2. Select [Display Log/Communication Test], and click [Communications Test].
Log Level and Leg Output Type
Log Level
1 2 3
- - -
- - Yes
- Yes Yes
Yes Yes Yes
Yes Yes Yes
4
Yes Detailed logs for debug
Yes Logs related to operations done on the system
Yes Update logs output by firmware type
Installation logs by MEAP application
Logs related to enabled functions by system option
Yes Logs for ordinary errors
Yes Logs for internal system errors
48
3. Technical Explanation (System)
Description