Canon LBP351 Series Service Manual page 178

Item
USB-H
SUBLOG TO USB
SHIPLOCK
MEAP
MEAP-PN
MEAP-SSL
CDS-MEAP
CDS-FIRM
CDS-UGW
CDS-LVUP
CDS-CTL
MEAP FUNCTION
LCDSFLG
CLEAR MEAP
CLEAR CDS
DDNSINTY
To set to enable/disable the USB host function.
By turning ON the host function, USB flash drive can be used.
CAUTION:
Points to note when pulling out the USB flash drive
• Be sure to pull out the USB flash drive after turning USB-H to OFF because the
USB flash drive is in the connected state when USB-H is ON.
• Pulling out the USB flash drive while it is being accessed causes an error.
ON: Use the USB host function.
OFF: Do not use the USB host function. (* default)
To output sublog to the USB flash drive.
It can be used regardless of the USB-H setting.
CAUTION:
It cannot be executed more than 2 times consecutively.
Since automatic recording of sublog can no longer be performed when executed
once, be sure to turn OFF and then ON the main power after execution.
Not use
To specify the port number of MEAP HTTP.
• 1 to 65535 (8000 *default)
To specify the port number of MEAP HTTPS.
• 1 to 65535 (8443 *default)
To set whether to permit the user administrator to install MEAP application.
• On*/Off
To set whether to permit the user administrator to update firmware.
• On/Off*
To set whether to permit firmware update from UGW.
• On/Off*
To set whether to permit service technician or user administrator to use the periodical update
function of CDS.
• On/Off*
It is a menu to switch countries for obtaining firmware via CDS.
Use this item to switch countries when obtaining firmware from another country due to the dis-
tance to the location server.
Use this item when "E602-0009" occurs. It is a menu to clear the error code and recover MEAP.
• ON: Recover MEAP. (default)
• OFF: Do not recover MEAP.
To set whether to allow the user administrator to use the CDS in local environment (L-CDS).
• On/Off*
To delete the following data retained by MEAP application at the next startup.
• MEAP application
• Data retained by MEAP application
• Data retained by the service-purposed area in the MEAP platform
To delete the CDS-related settings at the next startup.
To change DDNS periodical update interval
• 0: Do not perform periodical update.
• 1 to 48: 1 to 48 hours (default value: 24)
NOTE:
[Description of terminology]
DDNS (Dynamic Domain Name System): A system to dynamically register and manage
the IP addresses which are dynamically allocated and their host names
171
Description
9. Service Mode