Leica GPS1200 Field Manual page 157

CONFIGURE
GSM/Modem AT
Command Lines
Configuration of Devices
Field Option
CR
<Data Bits:> 6, 7 or 8
<Stop Bits:> 1 or 2
<Flow None or
Control:> RTS/CTS
Next step
IF the device is a
radio or device other than digital
cellular phone or modem
digital cellular phone or modem
For <GPRS/Internet: Yes> in CONFIGURE XX Device, this screen consists of two
pages. The following table lists the fields of both pages.
Description of fields
Field Option
<Init 1:> User input
<(cont):> User input
<Init 2:> User input
<Dial:> User input
<Hangup:> User input
<Escape:> User input
<Connect:> User input
When the device is used, between <Init 1:> and <Init 2:>, a check for the PIN is
performed.
Next step
Step Description
1. STORE (F1) returns to CONFIGURE XX Device.
Description
Not available for RS232 device. The terminator
is a carriage return.
Number of bits in a block of digital data.
Number of bits at the end of a block of digital
data.
Activates hardware handshake.
THEN
STORE (F1) to close the screen and to return to
the screen from where CONFIGURE XX Device
was accessed.
ATCMD (F4). Refer to paragraph "CONFIGURE
GSM/Modem AT Command Lines".
Description
Initilisation sequence to initilise digital cellular
phone/modem.
Allows the <Init X:> or the <Connect:> string to
continue onto a new line.
Initilisation sequence to initilise digital cellular
phone/modem.
Dialing string used to dial the phone number.
Hangup sequence used to end the network
connection.
Escape sequence used to switch to the
command mode before using the hangup
sequence.
Dialing string used to dial into the Internet.
GPS1200 157