Leica GPS1200 Field Manual page 135

CONFIGURE
Additional Refer-
ence Options,
General page
Config...\Interfaces... - General
Field Option
Port x
Port 1
Next step
REF (F2) changes to CONFIGURE Additional Reference Options, General page.
Description of fields
Field Option
<Ref Stn ID:> User input
<Time Yes or No
Slicing:>
<Used Ref 2, 3 or 4
Stations:>
<Time Slot:> 2, 3 or 4
The contents of
the choicelist
depends on the
settings for
<Used Ref
Stations:>.
<End of Nothing or CR
Message:>
<RTCM 2.1, 2.2 or 2.3
Version:>
Next step
PAGE (F6) changes to the NTRIP page.
Description
The physical port P1, P2 or P3 on the instrument
to which the device is attached.
Available for RX1250. LEMO port on RX1250.
Description
An identification for a reference station. It is
converted into a compact format and sent out
with real-time data in all real-time data formats.
It is different from the point ID of the reference
station.
An ID of the reference station is required if
working with several reference stations in time
slicing mode on the same frequency. In this
case, the ID of the reference station from which
data is to be accepted must typed in at the rover.
The possibility to send real-time messages
delayed. This is required when real-time
messages from different reference stations are
sent on the same radio channel. Time slicing
works for all device types.
Available for <Time Slicing: Yes>.
The number of reference stations in use from
where real-time messages are sent.
Available for <Time Slicing: Yes>.
The time slot represents the actual time delay.
The number of possible time slots is the number
of reference stations in use. The time delay
equals 1 s divided by the total number of refer-
ence stations.
To add a Carriage Return at the end of the real-
time message.
Available for <R-Time Data: RTCM XX v2> in
CONFIGURE Real-Time Mode.
The same version must be used at the reference
and the rover.
GPS1200 135