Leica GPS1200 Field Manual page 110

CONFIGURE
Post-Process Stop
Criteria
110
IF parameters for
<Auto STOP:>
are to be configured <R-Time Mode: Rover> PARAM (F3) changes to
Description of fields
The parameters shown on this screen depend on the setting for <STOP Criteria:>
in CONFIGURE Point Occupation Settings.
Field Option
<Time at User input
Point:>
<Number of User input
Obs:>
<At Logging Output
Rate:>
<n satellites User input
for:>
Next step
Step Description
1. CONT (F1) closes the screen.
2. CONT (F1) returns to the screen from where CONFIGURE Point Occu-
pation Settings was accessed.
AND
Description
Sets the required observation time for each
point. Counting time starts when OCUPY (F1) is
pressed.
Sets the required number of observations that
should be recorded at each point. Counting
observations starts when OCUPY (F1) is
pressed.
Displays the rate at which static raw observa-
tions are logged as configured in CONFIGURE
Logging of Raw Obs.
Sets the required observation time depending
on the number of satellites available. Counting
time starts when OCUPY (F1) is pressed. The
receiver stops measuring when the set length of
time for a certain number of satellites is reached.
Should the number of available satellites
change during observation, the observations
already recorded will be taken into account.
GPS1200
THEN
CONFIGURE Real-Time Stop
Criteria. Refer to paragraph
"CONFIGURE Real-Time Stop
Criteria".
Config...\Survey Settings...