Commissioning; General Information; Safety Instructions; Dangerous Contact Voltage - Siemens ULTRAMAT 23 Manual

Commissioning

6.1

General information

The analyzer has been parameterized and calibrated prior to delivery. However, a large
number of parameters can be subsequently adapted to specific requirements using menu-
based functions.
The following sections provide you with information on the display and operator panel as well
as the operating modes. You will learn how to scan analyzer statuses, how to calibrate the
analyzer, and how you can enter or modify parameters.
The input sequences are described using the maximum configuration. If your analyzer has a
different configuration (different measured components, number of infrared ranges, no
oxygen measuring cell, no pump, no serial interface etc.), the explanations can be applied
accordingly.
The used numbers must be considered as examples. They therefore probably differ from the
values displayed on your analyzer. The corresponding line remains empty if components are
not present in your analyzer.
If analyzers are installed in closed analysis cabinets, opening the cabinet door may result in
brief drifting of the measured values. This is a result of the temperature exchange which then
takes place.
6.2

Safety instructions

6.2.1

Dangerous contact voltage

Dangerous contact voltage
Danger of injury through dangerous contact voltage when the device is open or not
completely closed.
The degree of protection specified on the nameplate or in Technical specifications
(Page 31) is no longer guaranteed if the device is open or not properly closed.
• Make sure that the device is securely closed.
ULTRAMAT 23
Manual, 3/2016, A5E37100388-003
WARNING
6
77