Siemens ULTRAMAT 23 Manual page 100

Operation
7.4 Operating modes
100
Now select components 1 to 4 for which the subsequently set
ranges are to apply. Up to four components can be present.
If your analyzer is configured accordingly, you can select an-
other component by pressing one of the
<↑> or <↓> keys. In this example, this is component 3.
Press the <ENTER> key. The analyzer switches one level lower
and now offers functions applicable to the selected measuring
range.
The adjacent display appears with the functions selectable for
this range (MR). You can select these by pressing the <↑> or
<↓> key, and branch to the selected function by pressing the
<ENTER> key.
In this example, the adjacent display appears following selec-
tion of the function "Switch ranges CO".
The first line contains the heading, the second line the parame-
ter and its value to be changed; the cursor is positioned in this
line. Only supplementary information is
present in lines 3 and 4.
To switch over the measuring range, proceed as follows:
• Press the <ENTER> key.
The cursor jumps to the measuring range number which you
can change using one of the <↑> and <↓> keys.
• The range definition is imported when you press the
<ENTER> key again, and you return to the start of the line.
You cannot carry out any further settings here. To do so, you
must leave the menu display again. This is possible:
• By pressing the <ESC> key. You then return by one step in
the menu sequence
• by pressing the <MEAS> key. You then have the following
possibilities:
– To process the previous menu item further using
<ENTER>
– or return to measuring mode using <↑> or <→> and
subsequently <ENTER>, where all modifications are
imported which you have made since the last decoding
operation,
– or return to measuring mode using <↓> and <ENTER>
without importing the modifications..
ULTRAMAT 23
Manual, 3/2016, A5E37100388-003