Storage - Elcometer PG70 Operating Instructions Manual

4. Press MEM to exit the data logging functions.
9.5 PRINTING A BATCH
A batch can, very simply, be sent to a communications program on a PC and then printed. The procedure
for printing a batch is outlined below:
1. Press MEM to activate the data logging functions and settings.
2. Press SEND to enter batch setup.
3. Use UP and DOWN to scroll to the batch to be printed (F-01, F-05, etc.).
4. Press SEND to select the batch to be printed. The display will flash the batch selected.
5. Use UP and DOWN to scroll to the flashing Prnt.
6. Press SEND to print the contents of the batch.
7. Press MEM at any time to exit the data logging functions.

10 STORAGE

Your gauge has a Liquid Crystal Display. If the display is heated above 50°C (120°F) it may be
damaged. This can happen if the gauge is left in a car parked in strong sunlight.
Always store the gauge in its case when it is not being used.
If the gauge is to remain unused for long periods of time, remove the batteries and store them separately.
This will prevent damage to the gauge in the event of malfunction of the batteries.
27