Table of Contents
Advertisement
3 GETTING STARTED
3.1 FITTING BATTERIES
Your gauge may be used with dry cell batteries or rechargeable batteries.
2 x LR6 (AA) alkaline batteries are supplied in the kit.
When the battery voltage is low the entire display will start to flash. When
this occurs the batteries should be replaced.
To fit or replace batteries:
1. Unscrew battery compartment cover.
2. Referring to battery polarity instructions on rear of gauge, insert
batteries into gauge ensuring correct polarity.
3. Replace battery compartment cover.
Remove the batteries from the gauge if it is to remain unused for a long
period of time. This will prevent damage to the gauge in the event of
malfunction of the batteries.
Note: Alkaline batteries must be disposed of carefully to avoid
environmental contamination. Please consult your local environmental
authority for information on disposal in your region.
Do not dispose of any batteries in fire.
3.2 CHOOSING THE TRANSDUCER
Information can be found on the Elcometer NDT Knowledge Centre on www.elcometerndt.com.
8
Battery
compartment
cover
Elcometer 207
Ultrasonic Thickness Gauge
ALRM
DIFF
ALRM
DIFF
SCAN
CAL
SEND
CAL
SEND
SCAN
IN
ON
IN
MM
OFF
MM
PRECISION GAUGE
R
Model PG70
Advertisement
Table of Contents
