Table of Contents
Advertisement
7. Press UP and DOWN to advance to the desired memory location.
8.2 STORING A MEASUREMENT
1. Press SEND to store a reading in the memory location.
The data logger will then automatically advance to the next memory location.
8.3 DELETING CONTENTS OF A MEMORY LOCATION
The user may require a memory location that is currently full to be over written. The procedure for deleting
(clearing) the contents of the memory location is outlined in the following steps:
Note: This procedure assumes the steps in 8.1 and 8.2 have been completed, and 8.2 is being repeated.
1. Press UP and DOWN to move to the memory location.
If the memory location is currently full, the display will flash the FuLL symbol.
2. Press CLR to delete the contents of the memory location. The display will flash the memory location
(L011, L099, etc.) and the CLr symbol.
8.4 DELETING CONTENTS OF AN ENTIRE BATCH
The user may require the contents of an entire batch to be cleared of all measurements. This would allow
the user to start a new list of measurements starting at memory location L001, for example. The procedure
is outlined in the following steps:
1. Press MEM to activate the data logging functions and settings.
2. Press SEND to enter batch setup.
3. Use UP and DOWN to scroll to the batch.
23
Advertisement
Table of Contents
