Measurement - Recording Your Readings (Pg70Dl Only) - Elcometer PG70 Operating Instructions Manual

8 MEASUREMENT - RECORDING YOUR READINGS (PG70DL ONLY)

The Model PG70DL is equipped with a data logger a useful feature for reporting your inspections. It
increases efficiency by reducing the time it takes to manually record the measurements during the
inspection process. The gauge can then be connected to a computer or serial printer to save and print the
results of the inspection.
The gauge has a memory capacity of 1000 readings. Measurements are stored in up to 10 batches (files),
each consisting of up to 100 readings (memory locations).
8.1 SETTING-UP THE DATA LOGGER
1. Switch on the gauge.
2. Press MEM to activate the data logger.
The display will flash FILE F-01 (or the last batch used).
3. Press SEND to enter batch setup. The current batch will be displayed (F-01, F-03, etc.)
4. Use UP and DOWN to scroll to the batch (1-10) that will be used.
5. Press SEND to select the batch.
6. Press MEM to access the memory locations in the batch selected.
The current memory location (L007, L039, etc.) and the status of the memory location will be
displayed. The memory location can contain one of three possible things:
• a measurement that was previously stored
• CLr in the display, indicating that the memory location is empty
• ObSt (obstruct) in the display, indicating that a measurement could not be obtained
22