Elcometer PG70 Operating Instructions Manual page 17

6.1.1 To select measurement mode
Model PG70
1. Press UP to switch between GAtE I-E, GAtE
E-E, GAtE Auto or GAtE PLAS.
2. Repeat until correct mode is displayed.
6.2 SCAN MODE
Scan mode is used to search a large region for the thinnest point.
Scan mode doubles the reading rate to 8 per second. As the transducer is scrubbed across the surface the
gauge searches for the lowest thickness value. When the transducer is removed, the gauge displays the
lowest thickness that was detected.
To switch scan mode on/off:
Model PG70
1. Press SCAn to toggle SCAn OFF or SCAn
On.
2. The gauge will display SCAn OFF or SCAn
On.
Model PG70DL
1. Select MODE/GAtE.
2. Press SEND to switch between GAtE I-E,
GAtE E-E, GAtE Auto or GAtE PLAS.
3. Press MODE to return to the measurement
screen.
Model PG70DL
1. Select MODE/SCAn
2. Press SEND to toggle scan mode on or off.
3. Press MODE to return to the measurement
screen.
15