Transferring Readings To A Computer - Elcometer PG70 Operating Instructions Manual

4. Press SEND to select the batch.
5. Use UP and DOWN to scroll to the flashing CLr F-05 (or the batch selected).
6. Press SEND. The display will show CLr?
7. Press CLR to confirm and clear the contents of the entire batch.
8. Press MEM to return to the measurement screen.
8.5 DELETING CONTENTS OF ALL BATCHES
1. Immediately press the CLR. The display will show CLr?
2. Press CLR to clear all batches.

9 TRANSFERRING READINGS TO A COMPUTER

Readings can be transferred from your gauge to a computer. The Model PG70 will transfer readings as they
are taken. The Model PG70DL will transfer readings as they are taken and also transfer the contents of its
memory.
A data transfer cable is used to connect the gauge to the computer. This cable is supplied with the Model
PG70DL, but must be ordered separately for the Model PG70 - see "vices available, and to arrange for non-
warranty service." on page 29.
Elcometer NDT recommends the use of ElcoMaster™ 2.0 software to transfer the data. Other types of
software may also be used.
ElcoMaster™ 2.0 is supplied with the Model PG70 & PG70DL.
24