Table of Contents
Advertisement
9.1 CONNECTING THE DATA TRANSFER CABLE
1. Plug the 9-pin female D-type connector on one end of the data transfer cable into the COM port on the
PC.
2. Plug the jack connector on the other end of the data transfer
cable into the RS232 data connection socket on the bottom
of the gauge.
9.2 SETTING-UP THE SOFTWARE
•
ElcoMaster™ 2.0 Software for Measurement Data. This
software allows the user to transfer data from the memory of
the gauge to a PC for archiving, analysis and reporting. Data
can be transferred using the PC connection cable.
ElcoMaster™ 2.0 includes all the charts that you may need together with a report designer to let you
design your reports the way you wish to see them.
All of this software can also be downloaded from the Elcometer NDT website www.elcometerndt.com.
9.3 TRANSFER SET UP
1. Connect your gauge to your PC using the optional cable.
2. Switch on your gauge.
3. Start the software and connect the gauge using the wizard. Then follow the on screen instructions.
IN
ON
IN
MM
OFF
MM
PRECISION GAUGE
R
RS232 data
connection
socket
25
Advertisement
Table of Contents
