Specifying Administrator Settings; System Settings - Konica Minolta BIZHUB 501 Copy Operations

12
12.4

Specifying administrator settings

This section describes the function and main registration parameters that can be specified after pressing the
[Utility/Counter] key, then touching [Administrator Settings].
12.4.1

System Settings

Power Save Settings
Parameter
Low Power Mode Set-
tings
Sleep Mode Settings
Power Save Key
Enter Power Save
Mode
Output Settings
Parameter
Print/Fax Output
Settings
Output Tray Set-
tings
Shift Output Each
Job
*1
If optional separator is installed, "Tray 2" is selected as the factory default.
*2
If optional separator is installed, "Tray 1" is selected as the factory default.
*3
If an additional output tray is installed on Finisher FS-522, "Tray 3" is selected as the factory default.
Note
The "Output Tray Settings" parameter is available only if the optional finisher or separator is installed.
When an additional output tray is installed optionally, the additional output tray is assigned as Tray 2,
and Tray 2 is assigned as Tray 3, in "Output Tray Setting".
[Bin Assignment] only appears if the optional mailbin kit is installed.
Date/Time Settings
Description
Specify the current date and time. In addition, the time zone can be set between -12:00
and 13:00 (in 30-minute increments).
12-28
Description
Specify the desired length of time (between 1 and 240 min-
utes) until the machine enters Power Save mode.
Specify the desired length of time (between 1 and 240 min-
utes) until the machine enters Sleep mode.
Select which low power mode is entered when the [Power
Save] key is pressed.
• Low Power:
The touch panel goes off and the machine enters a mode
where it conserves energy.
• Sleep:
Although the machine conserves more energy in Sleep
mode than in Power Save mode, the machine must warm
up when Sleep mode is canceled, therefore taking more
preparation time than Power Save mode.
Specify settings for faxing. For details, refer to the User man-
ual – Network Scan/Fax/Network Fax Operations.
Description
Specify settings for faxing and printing. For details, refer to the User manual – Network
Scan/Fax/Network Fax Operations and the User manual – Print Operations.
Select the finishing tray for each type of job (copies, printouts, re-
ports and faxes).
Select whether or not printed copies are fed out shifted when "Off-
set" is selected while a finisher is installed.
• Yes: Pages are fed out shifted.
• No: Pages are fed out without being shifted.
Utility mode
Default Setting
15 minutes (bizhub 501)
1 minute
(bizhub 421/361)
60 minutes (bizhub 501)
15 minutes
(bizhub 421/361)
Low Power
Normal
Default Setting
*1
Copy: Tray 1
*1
Printer: Tray 1
Print Reports: Tray 2
*2*3
Fax: Tray 2
Yes
Default Setting
Time Zone: +00:00
bizhub 501/421/361 (Version 2)
*2*3