Polycom Pano Administrator's Manual page 55

e. Save your settings. The monitor will adjust to the resolution.
6. Set up the monitor profile for the Polycom video system monitor:
a. Open a web browser and enter the IP address of the Polycom video system.
b. Go to Admin Settings > Audio/Video > Monitors.
c. For Monitor 1 at Monitor Profile, select Content, then Far, then Near.
7. Restart the Polycom video system.
8. Connect one end of an HDMI cable to the HDMI Input port on the Polycom video system (see
images below for port location). Connect the other end of the cable to an Output port on the
splitter. For RealPresence Group 700 systems, you must connect the HDMI cable to Input port 3.
The Polycom Pano system will start presenting on the Polycom video system once the systems
and monitors are connected. You must continue with the following steps to pair the systems and
complete the setup process.
9. Open a supported web browser, enter the IP address of the Polycom Pano system, and go to
General Settings > Pairing
10. Enter the IP address, Admin ID, and Admin password that are associated with the Polycom video
system. If no password is set, leave the Admin password field blank.
11. Select Connect. The Pair button appears only when the connection in the step above is
successful. Once pairing is successful, the Pair button changes to Update.
12. Test that content sharing functions properly.
Polycom, Inc.
Sending Content to a Polycom Video System
53