Sending Content To A Polycom Video System; Supported Polycom Video Systems; Connect A Polycom Video System Using Two Monitors; Connect A Polycom Video System Using Two Monitors (Non-Touch Monitor Setup) - Polycom Pano Administrator's Manual

Sending Content to a Polycom Video
System
Topics:
▪

Supported Polycom Video Systems

▪

Connect a Polycom Video System Using Two Monitors

▪ Connect a Polycom Video System Using Three Monitors
▪ Test Content Sharing
▪ Unpair a Polycom Video System
A Polycom Pano system can send content to a Polycom video system. Once the required setup is
complete, no further action is required to enable content sharing. The Polycom Pano system detects
when content is available and automatically presents to the Polycom video system.
You can pair a Polycom Pano system with a Polycom video system using two or three monitors:
▪ Two Monitors Configure the Polycom Pano and Polycom video system to present content on the
second monitor
▪ Three Monitors Integrate the Polycom Pano system with the Polycom video system, and
configure the Polycom Pano system to present content on the third monitor. Note that for this setup
option, the Polycom Pano content displays on two monitors.
Keep the following in mind when enabling content on a Polycom video system:
▪ The Polycom Pano system must initiate the content sharing request.
▪ Far site annotations on the Polycom Pano content are not supported.
▪ Make sure you disable the VisualBoard application in the web interface.
Supported Polycom Video Systems
Polycom Pano systems can pair with the following Polycom video systems:
®
▪ Polycom RealPresence
or later.
▪ Polycom ® RealPresence Centro
Connect a Polycom Video System Using Two Monitors
You can pair a Polycom Pano system with a Polycom video system using two monitors.
Connect a Polycom Video System Using Two Monitors (Non-Touch
Monitor Setup)
You can connect a Polycom Pano system to a Polycom video system using two monitors when the
Polycom Pano monitor does not have touch capability, as shown in the following diagram:
Polycom, Inc.
®
Group Series 310, 500, 550, and 700 systems with software version 6.0
™ systems with software version 6.0 or later.
49