Configuring The Network; Connect To The Lan; Lan Status Lights; Configure Ip Address Settings - Polycom Pano Administrator's Manual

Configuring the Network

Topics:
▪

Connect to the LAN

▪

LAN Status Lights

▪

Configure IP Address Settings

▪ Configure DNS Settings
▪ Configure LAN Options
The topics in this section cover network types used worldwide, but keep in mind that not all network types
are available in all countries.
Connect to the LAN
You must connect the Polycom Pano system to a LAN to share content and access the web interface.
LAN Status Lights
The LAN connector on the Polycom Pano device has two lights to indicate connection status and traffic.
Indicator Light
Both lights off
Green and yellow lights on
Green light on and blinking yellow light
Configure IP Address Settings
You can configure IPv4 and IPv6 settings in the web interface.
Procedure
1. Select one of the following options to specify how the IP address of the Polycom Pano system is
obtained:
▪ Obtain IP address automatically.
▪ Enter IP address manually.
2. Configure the following IPv4 settings:
Polycom, Inc.
Connection Status
No 10/100/1000 Base-T connection and no network
traffic.
10/100/1000 Base-T connection.
10/100/1000 Base-T connection with network traffic
20