Running The Setup Wizard; Modes Of Operation; Run The Setup Wizard - Polycom Pano Administrator's Manual

Running the Setup Wizard

Topics:
▪

Modes of Operation

▪

Run the Setup Wizard

The setup wizard, also known as the the out-of-box (OOB) state, walks you through the initial setup steps.
You must launch and run the setup wizard to configure your Polycom Pano system.
Modes of Operation
When you run the Polycom Pano setup wizard, you are presented with two setup options:
▪ Standalone You bypass Polycom Cloud Service registration and configure the Polycom Pano
system as a standalone system. In this mode, you control system operations automatically or
manually.
▪ Cloud You register a Polycom Pano system with the Polycom Cloud Service. System operations,
such as software updates, are automatically controlled.
Polycom Cloud Service registration requires that your organization first complete the Polycom
Cloud Service activation process.
Related Links
Register a Polycom Pano Device with the Polycom Cloud Service
Run the Setup Wizard
Keep the following in mind about the setup wizard:
▪ You must have a web browser and a network connection to access the Polycom Pano web
interface.
▪ The setup wizard allows you to set an Admin password to limit access to the administrator settings.
The default Admin ID is admin and the default admin password consists of the last six characters
of the Polycom Pano system serial number.
The Admin password is case-sensitive.
If you forget the Admin password, you must reset the system to run the setup wizard again. This will
allow you to access the Admin settings and reset the password.
▪ The setup wizard is available during initial setup, after a system reset with system settings deleted,
and after initiating factory reset.
Note: Make sure you complete the entire setup process. A timeout occurs after 10 minutes, and the
system returns to the Sign In screen.
Procedure
1. Connect the monitor and network cables.
Polycom, Inc.
on page 18
14