Adjusting The Track - Otto Bock Ventus Instructions For Use Manual

Adjustments
3) Loosen the clamping screw on the clamping flange (see fig. 9, item 1, see fig. 15, item 1).
NOTE: The exchange can be made on one side first and then on the other or simultaneously.
NOTE: The track width must be adjusted symmetrically on both sides.
4) Remove the camber module:
→ Only for camber module 0°/3°: Insert the quick-release axle of the rear wheel into the camber module to
assist removal (see fig. 14, item 1/2) and pull it out with the help of the quick-release axle.
→ Only for camber module 6°/9°: Remove the camber module including fitting by hand (see fig. 16, item 1).
5) Replace and install the camber module.
→ Set the track width so that the slanted rear wheels can run freely (see Page 12).
→ Only for camber module 0°/3°: The entire camber module must be fully enclosed by the clamp fitting dur­
ing installation. Check the position by measuring it afterwards (see fig. 11).
→ Only for camber module 6°/9°: During installation, the camber module must be inserted in the clamping
flange to the stop (see fig. 16, item 2).
6) Clamp the camber module lightly using the clamping screw on the clamping flange.
7) Replace the camber module on the other side in the same fashion. Make sure that both camber modules have
been adjusted symmetrically.
8) Attach the wheels.
9) Make the track adjustments (see Page 14).
10) Tighten the clamping screws to 10 Nm (see fig. 9, item 1; see fig. 15, item 1).
13
15

6.2.5 Adjusting the track

INFORMATION
► The track must be adjusted after the following adjustments have been made:
→ Adjusting the track width: see Page 12
→ Adjusting the rear wheel camber: see Page 13
► The track setting must be checked and, if necessary, adjusted after the following adjustments have been
made:
→ Adjusting the horizontal position of the rear wheel: see Page 10
→ Adjusting the height of the rear wheel: see Page 10
14 | Ottobock
14
16
Ventus