AT-28
AUTOMATIC TRANSMISSION (STATION WAGON) - TROUBLESHOOTING
MANUAL SHIFTING TEST
HINT: With this test, it can be determine whether the
trouble lies within the electrical circuit or is a mechanical
problem in the transmission.
1.
DISCONNECT SOLENOID WIRE
2.
INSPECT MANUAL DRIVING OPERATION
Check that the shift and gear position correspond with
the table below.
HINT: If the L, 2 and D range gear position are difficult
to distinguish, perform the following road test.
• While driving, shift through the L, 2 and D ranges.
Check that the gear change corresponds to the shift
position.
• If any abnormality is found in the above test, the prob-
lem lies in transmission ifself.
3.
CONNECT SOLENOID WIRE
4.
CANCEL OUT DIAGNOSTIC CODE
(See page AT-20)