AUTOMATIC TRANSMISSION (STATION WAGON)
(c)
Connect the oil temperature sensor connector.
11. REMOVE OIL FILLER TUBE
(a)
Install the filler tubes with the bolt.
(b)
Install the bolt.
(c)
Install the level gauge.
12. (w/ MECHANICAL WINCH)
INSTALL POWER TAKE-OFF DRIVE SHAFT
(a) Align the matchmarks on the joint flange yoke and drive
shaft.
(b) Install the drive shaft.
(c) Align the matchmarks on the drive shaft and PTO.
(d) Torque the nuts.
Torque: 20 Nm (200 kgfcm, 14 ft-lbf)
ASSEMBLY REMOVAL
AND INSTALLATION
AT-81