Inspect Throttle Cable; Inspect Transmission Shift Lever Range - Toyota LAND CRUISER Service Manual Supplement
Hide thumbs
Also See for LAND CRUISER:
- Owner's manual (623 pages) ,
- Repair manual (19 pages) ,
- Owner's manual (256 pages)
Table of Contents
Advertisement
AT-26
AUTOMATIC TRANSMISSION (STATION WAGON)
(f)
Check the fluid level with the normal operating tempera-
ture (70 — 80°C or 158 — 176°F) and add as neces-
sary.
NOTICE: Do not overfill.
3.
INSPECT THROTTLE CABLE
(a)
Check that the throttle cable is installed correctly and not
bent.
(b)
With the throttle valve fully closed, measure the distance
between the end of the boot and stopper on the cable.
Standard distance:
(1FZ-FE engine) 0 — 1 mm (0 — 0 . 0 4 in.)
(1HD-T engine) 0 . 5 - 1.5 mm ( 0 . 0 2 0 - 0 . 0 5 9 in.)
If the distance is not standard, adjust the cable by the ad-
justing nuts.
4.
INSPECT TRANSMISSION SHIFT LEVER RANGE
When shifting the shift lever from the N range to other
ranges, check that the lever can be shifted smoothly and
accurately to each range and that the position indicator
correctly indicates the position.
If the indicator is not aligned with the correct position,
carry out the following adjustment procedures.
(a)
Loosen the nut on the control rod.
(b)
Push the control shaft lever fully toward the rear of the
vehicle.
(c)
Return the control shaft lever two notches to N range.
(d)
Set the shift lever to N range.
(e)
While holding the shift lever lightly toward the R range
side, tighten the control rod nut.
(f)
Start the engine and make sure that the vehicle moves
forward when shifting the lever from the N to D range
and reverse when shifting it to the R range.
TROUBLESHOOTING
Advertisement
Table of Contents
Troubleshooting
