BODY ELECTRICAL SYSTEM - POWER SEAT CONTROL SYSTEM
POWER SEAT MOTOR
SLIDE MOTOR INSPECTION
MOTOR OPERATION
(a)
Connect the positive ( + ) lead from the battery to ter-
minal 1 and the negative ( —) lead to terminal 2, check
that the motor turns counterclockwise.
(b)
Reverse the polarity, check that the motor turns clock-
wise.
If operation is not as specified, replace the motor.
CIRCUIT BREAKER OPERATION
(a)
Connect the positive ( + ) lead and the negative ( —) lead
from the battery to slide motor connector (illustrated ter-
minals), and slide the seat to front end position.
(b)
Continue to apply voltage, check that there is a circuit
breaker operation noise within 4 to 60 seconds.
(c)
Reverse the polarity, check that the seat begins to move
backwards within approximately 60 seconds.
If operation is not as specified, replace the motor.
FRONT VERTICAL MOTOR INSPECTION
MOTOR OPERATION
(a)
Connect the positive ( + ) lead from the battery to ter-
minal 1 and the negative ( —) lead to terminal 2, check
that the motor turns counterclockwise.
(b)
Reverse the polarity, check that the motor turns
clockwise.
If operation is not as specified, replace the motor.
CIRCUIT BREAKER OPERATION
(a)
Connect the positive ( + ) lead and the negative ( —) lead
from the battery to the front vertical motor connector (il-
lustrated terminals), and move the front edge of seat
cushion to the highest position.
(b)
Continue to apply voltage, check that there is a circuit
breaker operation noise within 4 to 60 seconds.
BE-25