MANUAL TRANSMISSION (HARDTOP & CANVAS TOP)
TRANSMISSION INSTALLATION
(See page MT-4)
1.
INSTALL TRANSFER TO TRANSMISSION
(a) Apply MP grease to the adaptor oil seal.
(b)
Install the transfer to the transmission.
HINT: Take care not to damage the oil seal by the input
gear spline when installing the transfer.
(c) Install and torque the bolts.
Torque: 37 N-m (380 kgf-cm, 27 ft-lbf)
2.
INSTALL ENGINE REAR MOUNTING
Install the engine rear mounting and torque the four bolts.
Torque: 59 N-m (600 kgf-cm, 43 ft-lbf)
3.
INSTALL TRANSMISSION TO ENGINE
(a) Align the input shaft spline with the clutch disc and in-
stall the transmission to the engine.
(b) Install and torque the ten bolts.
Torque: 72 N-m (730 kgf-cm, 53 ft-lbf)
4.
INSTALL CROSSMEMBER
(a) Raise the transmission slightly with a jack.
(b)
Install the crossmember with eight bolts and two nuts.
Torque: BOLT 39 N-m (400 kgf-cm, 29 ft-lbf)
NUT
76 N-m (780 kgf-cm, 56 ft-lbf)
(c)
Remove the jack.
TRANSMISSION REMOVAL
AND INSTALLATION
MT-9