BRAKE SYSTEM (STATION WAGON) - LOAD SENSING PROPORTIONING
BR-14
AND BY-PASS VALVE (LSP & BV)
FLUID PRESSURE CHECK AND ADJUSTMENT
1.
SET REAR AXLE LOAD
Rear axle load (include vehicle weight):
1,330 kg (2,932 Ib)
2.
INSTALL LSPV GAUGE (SST) AND BLEED AIR
SST 09709-29017
3.
RAISE FRONT BRAKE PRESSURE TO 7,845 kPa (80
2
kgf/cm
,
1,138 psi) AND CHECK REAR BRAKE
PRESSURE
Rear brake pressure:
5,984 ± 589 kPa (61 ± 6 kgf/cm
HINT:
The brake pedal should not be depressed twice
and/or returned while setting to the specified pressure.
Read the value of rear pressure two seconds after ad-
justing the specified fluid pressure.
4.
IF NECESSARY, ADJUST FLUID PRESSURE
(a)
Disconnect the No.2 shackle from the shackle bracket.
(b)
Adjust the length of the No.2 shackle turning it.
Low pressure — Lengthen A
High pressure — Shorten A
Initial set:
90 mm (3.54 in.)
Adjusting range:
84 - 96 mm (3.31 - 3.78 in.)
HINT:
One turn of the No.2 shackle changes the fluid
pressure about following specification.
98.1 kPa (1.0 kgf/cm
2
, 869 ± 86 psi)
2
, 14.2 psi)