Control Link Assembly Adjustment; Adjust Control Link Assembly - Toyota LAND CRUISER Service Manual Supplement

BODY ELECTRICAL SYSTEM - CRUISE CONTROL SYSTEM
(b) When the arm is moving from the closed to open position,

CONTROL LINK ASSEMBLY ADJUSTMENT

ADJUST CONTROL LINK ASSEMBLY

(a)
(b) With the magnetic clutch ON, connect the positive ( + )
(c) With the magnetic clutch ON, connect the positive ( + )
(d)
(e)
(f)
(g)
check that resistance between terminals 2 and 3 in-
creases from approx. 0.5 to 1.7
If operation is not as specified, replace the motor.
Connect the positive ( + ) lead from the battery to ter-
minal 5 and the negative ( —) lead to terminal 4 of the ac-
tuator.
(magnet clutch turned ON)
NOTICE: Keep the magnet clutch ON until adjustment
of control link assembly is completed.
lead from the battery to terminal 6 and the negative ( —)
lead to terminal 7.
(Arm moves to the open side.)
lead from the battery to terminal 7 and the negative ( —)
lead to terminal 6.
(Arm moves to the close side.)
Install the control link assembly to the actuator.
Rotate the control link assembly so that the catch of the
control link assembly's lower side link comes in contact
with the actuator control arm (Free play 0).
Free play: 0 mm (0 in.)
NOTICE: Rotate the lower side link to the right until it
touches the stopper.
In condition (d), install and torque the three nuts.
Disconnect lead wire from the actuator.
BE-49