Toyota LAND CRUISER Service Manual Supplement page 44

MANUAL TRANSMISSION (HARDTOP & CANVAS TOP) - OUTPUT SHAFT
4. REMOVE HUB SLEEVE NO.1 ASSEMBLY, SYNCHRO-
NIZER RING, SECOND GEAR AND NEEDLE ROLLER
BEARING
(a) Using two screwdrivers and a hammer, drive out the
snap ring.
(b) Using a press, remove the hub sleeve No.1 assembly,
synchronizer rings, and second gear.
(c) Remove the needle roller bearing.
5. REMOVE HUB SLEEVE NO.1, SHIFTING KEYS AND
SPRING FROM CLUTCH HUB NO.1
Using a screwdriver, remove the three shifting keys and
t w o springs from the clutch hub No.1.
6. REMOVE HUB SLEEVE NO.2 ASSEMBLY, SYNCHRO-
NIZER RINGS, THIRD GEAR AND NEEDLE ROLLER BEAR-
ING
(a) Remove two screwdrivers and a hammer, drive out the
snap ring.
(b) Shift hub sleeve No.3 onto the fifth gear.
MT-15