BODY ELECTRICAL SYSTEM - COMBINATION METER
SEAT BELT WARNING SYSTEM
SEAT BELT WARNING INSPECTION
INSPECT WARNING LIGHT
(a)
(b) Ground terminal 2 on the wire harness side connector.
(c) Turn the ignition switch ON, check that the warning light
SEAT BELT BUCKLE SWITCH INSPECTION
INSPECT SWITCH
(a)
(b)
DOOR COURTESY SWITCH
DOOR COURTESY SWITCH INSPECTION
SEAT BELT WARNING RELAY INSPECTION
RELAY CIRCUIT
Disconnect the connector from the seat belt warning
relay.
lights up.
If the warning light does not light, test the bulb.
Check that there is no continuity between terminals with
the switch ON (belt unfastened).
Check that there is continuity between terminals with the
switch OFF (belt fastened).
If operation is not as specified, replace the seat belt inner.
See page BE-16
Disconnect the connector from the relay and inspect the
connector on the wire harness side as shown in the chart.
BE-17