BRAKE SYSTEM (STATION WAGON) - MASTER CYLINDER
MASTER CYLINDER DISASSEMBLY
1.
2.
(a)
(b)
3.
4.
5.
6.
7.
(a)
(b)
REMOVE MASTER CYLINDER BOOT
Using a screwdriver, remove the master cylinder boot.
REMOVE RESERVOIR CAP AND STRAINER
Turn the reservoir cap to the " O P E N " side and remove it.
Remove the strainer.
REMOVE RESERVOIR
Remove the set screw and pull out the reservoir.
REMOVE TWO GROMMETS
PLACE CYLINDER IN VISE
REMOVE NO.2 PISTON STOPPER BOLT
Using a screwdriver, push the pistons in all the way and
remove the No.2 piston stopper bolt and gasket.
HINT:
Tape the screwdriver tip before use.
REMOVE TWO PISTONS
Push in the piston with a screwdriver and remove the
snap ring with snap ring pliers.
Remove the No.1 piston and spring by hand, pulling
straight out, not at an angle.
NOTICE:
If pulled out at an angle, there is a possibility
that the cylinder bore could be damaged.
BR-9