Remote Control; Introduction; Remote Control Id; Monitor - Bosch Plena Installation And User Instructions Manual

Plena Voice Alarm System | Installation and User Instructions | Configuration
22

Remote control

22. 1

Introduction

The remote controls are configured using a DIP switch
(see figure 22.1).
figure 22. 1 : Remote control settings

22.2 Remote control ID

The ID of the remote control is set using the RCP ID
switch. The ID of the remote control must be the same
as the number of the Remote Control Panel connection
of the voice alarm controller to which the remote
control is connected (1 to 2). Actions that are started by
the remote control with ID 1 have a higher priority than
actions that are started by the remote control with ID 2.

22.3 Monitor

If the Monitor switch is in the ON position, the internal
monitoring loudspeaker of the remote control is
switched on. The volume of the monitoring loudspeaker
is set with the Monitoring Speaker volume control on the
rear panel of the remote control.

22.4 Termination switch

If there are no remote control extensions connected to
the remote control, the Termination switch must be in
the ON position.
Bosch Security Systems | 2006-06 | 9922 141 10377 en
23

Remote control extension

23. 1 Introduction
The remote control extensions are configured using an
ID selector and a switch (see figure 23.1).
3
Termination
ID
Off
6
1...9
figure 23. 1 : Remote control settings

23.2 Remote control extension ID

The ID of the remote control extension is set using a ID
selector. The remote control extension only controls the
voice alarm router that has the same ID. Furthermore,
each remote control extension that is connected to the
same remote control must have a unique ID (1 to 9).
23.3 Termination switch
The last remote control extension in a sequence of
looped-through remote control extensions must always
be terminated. Only for these remote control
extensions, put the Termination switch in the ON
position.
en | 83
RCP ext. In RCP ext.
On