Lbb1998/00 Voice Alarm Remote Control Kit; Introduction; Overview; Installation - Bosch Plena Installation And User Instructions Manual

Plena Voice Alarm System | Installation and User Instructions | Equipment
10 LBB1998/00 Voice Alarm
Remote Control Kit
10. 1

Introduction

With the LBB1998/00 Voice Alarm Remote Control
Kit, it is possible to make customized remote controls
that can be connected to the voice alarm controller. The
remote control kit provides the same functionality as the
LBB1996/00 Voice Alarm Remote Control.
10.2

Overview

See figure 10.1 for an overview of the front panel of the
remote control kit. The rear panel of the remote control
kit is the same as the rear panel of the LBB1996/00
Voice Alarm Remote Control (see figure 9.1).
Plena
Voice Alarm Remote Control Kit
Processor reset
Network
Call/EMG.
Music/Spare
Ground short
Input
Mains
Speaker
Power
-20dB
-6dB
0dB
Disable
Alert Message
Alarm Message
EMG Mic
figure 10. 1 : Front and rear views of the remote control kit
10.3

Installation

The remote control kit is suitable for table-top and 19-
inch rack mounting installation. Two brackets for rack-
mounting are supplied. Installing a remote control kit is
similar to installing a voice alarm controller (see section
5.2).
Bosch Security Systems | 2006-06 | 9922 141 10377 en
LEDS/LAMPS
200mA Max. input
1 2 3 4 5 6 1 2 3 4 5 6
Zone 1~6B
Zone 1~6A
RCP Ext.
Controller/Router
EMG mic
Message
Battery
LEDS/LAMPS
200mA Max. input
+
_
Fault Reset
Fault Ack
Indicator test
All call
Alarm Message
Alert Message
EMG Switch
EMG State Lamp
LEDS/LAMPS
200mA Max. input
External Power Supply
200mA max.
50V DC max.
1 2 3 4 5 6 1 2 3 4 5 6
EMG Ack
EMG Reset
EMG Zone Indicator 1~6
24V out
5K ohm
< 5mA
LEDS/LAMPS input
Call/BGM
Zone selection
GND 24V out
0.2A Call Zone 1
Call Zone 2
Call Zone 3
Call Zone 4
Call Zone 5
Call Zone 6
en | 58
1 2 3 4 5 6
BGM Zone Indicator 1~6
GND
Call Zone Indicator 1~6
GND
EMG mic
BGM Zone 6
BGM Zone 5
BGM Zone 4
BGM Zone 3
BGM Zone 2
BGM Zone 1