Plena Voice Alarm System | Installation and User Instructions | Configuration
20
Voice alarm router
20. 1
Introduction
The voice alarm routers are configured using an ID
selector and a DIP switch (see figure 20.1).
ID
1...9
Booster 2
figure 20. 1 : Router settings
20.2 Router ID
The ID of the voice alarm router is set using an ID
selector. Each voice alarm router must have a unique ID
(1 to 9). Use a small screwdriver to turn the arrow in the
correct position.
20.3 Termination switch
The last voice alarm router in a sequence of
looped-through routers must always be terminated.
Only for these voice alarm routers, put the Termination
switch in the ON position.
Bosch Security Systems | 2006-06 | 9922 141 10377 en
Router
Termination
In
Firmware upgrade
Off
Out
On
Firmware Upgrade
en | 81