Plena Voice Alarm System | Installation and User Instructions | Important Notices
Important Notices
When using routers, keypads or more than one call
station, configure the controller using the supplied
software.
Use shielded cable (Cat-5) between the routers and the
controller. Do not connect the shield to both the
controller and the router!
The factory default setting of the Plena Voice Alarm
Controller is as follows:
•
Stand-alone unit configured for an ISO 60849
compliant system when used with a spare power
amplifier from the Plena range and compliant wiring
and loudspeakers.
•
One channel system.
•
Supervision on for:
•
Loudspeaker lines
(90 seconds interval, 15% accuracy)
•
Main and spare power amplifier
•
Short to ground ("Ground short")
•
Mains and battery power
•
EMG mic
•
Memory
•
For the remote controls to function, all firmware
must be version 2.0 or higher. The factory-installed
firmware is indicated on every component of the
voice alarm system (LBB1990/00, LBB1992/00,
LBB1956/00, LBB1995/00, LBB1996/00,
LBB1997/00, LBB1998/00, LBB1999/00). If a label
is not present, the firmware version is 1.x.
Thank you for choosing a Bosch Security Systems
product.
Bosch Security Systems | 2006-06 | 9922 141 10377 en
en | 4