Installation; External Connections; Technical Data - Bosch Plena Installation And User Instructions Manual

Plena Voice Alarm System | Installation and User Instructions | Equipment
5 Ground - A connection to electrically ground the
remote control extension.
6 Firmware upgrade connector - An RS232
connector to connect a PC to upgrade the firmware
of the remote control extension.
7 Firmware upgrade switch - A switch to upgrade
the firmware of the remote control extension.
8 System sockets - Two redundant RJ45 sockets to
connect the remote control extension to the remote
control (see section 9.3.2).
9 Configuration settings - A set of DIP switches to
configure the voice alarm router (see 23).
10 Remote control extension ID - A rotary switch
to set the ID of the remote control extension (see 23).
11 Trigger outputs - Three general purpose trigger
outputs. For future use.
12 Status output - One status output to send the status
of the Plena Voice Alarm System to third party
equipment (see section 11.3.2).
13 24 V DC input - One 24 V(DC) input to connect
the remote control panel to a power supply (see
section 11.3.3).
11.2

Installation

The remote control extension is suitable for table-top
and 19-inch rack mounting installation. Two brackets
for rack-mounting are supplied. Installing a remote
control extension is similar to installing a voice alarm
controller (see section 5.2). The brackets can also be
used to attach the remote control extension to a wall.
11.3

External connections

11.3.1 Remote control
Connect the remote control extension to the remote
control (see section 9.3.2).
Bosch Security Systems | 2006-06 | 9922 141 10377 en
11.3.2 Status output contacts
The remote control extension has 1 status output
contacts to indicate the current system state. The
procedure for connecting the status outputs is the same
as the procedure for connecting status outputs to the
voice alarm controller (see section 5.3.11).
11.3.3 Power
Connect a back-up power supply to the remote control
extension (see figure 11.2).
figure 11.2: Connecting a power supply
11.4

Technical data

EMC emission:
According to EN55103-1
EMC immunity:
According to EN55103-2
Current consumption:
50 mA (idle)
200 mA (indicator test)
Dimensions:
88 x 432 x 90 mm
Weight:
1.8 kg
en | 61
PLN -V6R
Plena C
RC V oice 890
Max. Pane l Alarm Syste 0199
300m input powe m 600 0 1
S/N. A, 24V r
D C
Desig A035413
The Nethe n & Quali
rlands ty NL-48 2 7HG-1 N663
0
Charger
-
+
2 4 V
D C