Exit Timers - Baum VarioUltra 20 User Manual

ring. Alarms are given as tone signals and/or vibration. The names of the
four alarm clocks, which are also displayed at wake-up time, can be
determined by the user. The alarms are switched off by default.
To set an alarm, proceed as follows:
1. From the main menu, select menu item Timers > Alarm clocks. A
dialog will open displaying the names and status of the four
alarms.
2. To amend the settings of, for example, Alarm 1, select its button.
3. Another dialog will open. Use the Check box "Active" to switch the
alarm on or off.
4. In the "Name" edit box the alarm (Alarm 1) can have another name
assigned, e.g. "normal alarm".
5. Enter the wake time in the next edit box; 08:00 is the default time
and can be overwritten.
6. Use the appropriate check box to determine the weekday the
alarm should go off.
7. The "Sound on" check box is activated by default.
8. The sound for the alarm can be selected from a list of short wav-
files. The path will be given in the "Sound file" field.
9. Select "Choose signal" if a different sound is to be set as the alarm
signal. A file list will open – move up and down the list to select the
desired file (cf. File manager). The TIMALARM.WAV, BELL.WAV
or ROOSTER.WAV files are recommended. Press B9 or Return to
confirm the default button "Apply", which will close the dialog. The
new alarm is now selected and its path given in the "Sound file"
field.
10. The "Vibration on" check box is unchecked by default. When
checking you get a list with pre-defined vibration patterns. Move
left or right to select the desired pattern and confirm OK.
11. Confirm with "OK" to finish the settings and exit the alarm
dialog with "OK".
When the wake-up time arrives VarioUltra will sound the selected alarm
and/or vibrate according to the selected pattern. A message will also be
displayed with the alarm name. If the alarm is ignored VarioUltra will
sound the alarm every 10 seconds for up to 3 minutes. You can
"snooze" the alarm by pressing any key except B9. In this case, the
dialog closes and the alarm activates again 10 seconds later.
To quit the alarm press B9 or confirm the OK button in the dialog.

8.4 Exit Timers.

86