Husqvarna 701 Enduro 2017 Owner's Manual page 185

21 TROUBLESHOOTING
Faults
Engine overheats.
Malfunction indicator lamp lights up or
flashes
N The idling speed indicator lamp
does not light up when the transmis-
sion is in neutral
Engine dies during the journey
The ABS warning lamp lights up
Possible cause
Too little coolant in cooling system
Radiator fins very dirty
Foam formation in cooling system
Buckled or damaged radiator hose
Thermostat is faulty
Fuse 4 blown
Defect in radiator fan system
Air in cooling system
Defect in fuel injection system
Gear position sensor not programmed
Lack of fuel
Fuse 1, 2 or 3 blown
The ABS fuse is blown
Large difference in wheel speeds of
the front and rear wheels
Malfunction in ABS
Action
–
Check the cooling system for leakage.
–
Check the coolant level. (
–
Clean radiator fins.
–
Drain the coolant. (
–
Fill/bleed the cooling system.
–
Change the radiator hose.
–
Check the thermostat.
–
Change the fuses of individual power
consumers. ( p. 146)
–
Check the radiator fan system.
–
Fill/bleed the cooling system.
–
Read out the fault memory using the Husqvarna
Motorcycles diagnostics tool.
–
Read out the fault memory using the Husqvarna
Motorcycles diagnostics tool.
–
Refuel. ( p. 57)
–
Change the fuses of individual power
consumers. ( p. 146)
–
Change the ABS fuses. (
–
Stop the vehicle, switch off the ignition, and
start it again.
–
Read out the ABS fault memory using the Husq-
varna Motorcycles diagnostics tool.
183
p. 159)
p. 161)
( p. 162)
( p. 162)
p. 143)